Equator ED622 Clothes Dryer User Manual


 
10 Electric Dryer Owner’s Manual
INSTALLATION INSTRUCTIONS (CONTD.)
SPECIAL INSTALLATION REQUIREMENTS
ALCOVE OR CLOSET INSTALLATION
WARNING: To reduce the risk of fire, the dryer MUST BE EXHAUSTED THE OUTDOORS. See
et and adjacent walls are: 2 either side and 3 front and rear.
imum of 60 sq. in. of open
lled in the same with closet with dryer.
INIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET INSTALLATIONS.
OBILE HOME INSTALLATION
outdoors with the termination securely fastened to the mobile home
obile home.
r. The free air opening shall not be
MUST BE METAL.
nstructions available from the dealer.
stallation Codes.
ELECTRICAL POWER SUPPLY
EXHAUST INFORMATION section.
Minimum clearances between dryer cabin
Minimum vertical space from floor to overhead cabinets, etc. is 52 (132cm).
Closet door must be louvered or otherwise ventilated and must contain a min
area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of
120 sq. in. of open area equally distributed.
No other fuel-burning appliance shall be insta
M
Minimum clearances to combustible surfaces: 2’’ clearance both sides and 3’’ rear.
M
The dryer must be exhausted to the
structure. (See
EXHAUST INFORMATION section.)
The exhaust MUST NOT be terminated beneath the m
Provisions must be made for the introduction of outside air into the drye
less than 12 sq. inches.
The exhaust duct material
The dryer must be attached to the floor following i
Installation must comply with the current
CAN / CSA Z240MH series Mobile Home In
NOTE: CONSIDERATION MUST BE GIVEN TO INSTALLING AND SERVICING THE APPLIANCE.
CAUTION: NEVER USE AN EXTENSION CORD WITH THIS APPLIANCE.
he rating plate of the
IONS
the event of malfunction or breakdown grounding will reduce the risk of
connection of the equipment grounding conductor can result in a risk of electric shock. Check
ify the plug provided with the appliance-if it will not fit the outlet; have a proper outlet installed by
Not r supply does not meet the specifications listed below, call a licensed electrician.
This dryer must be connected to n individual circuit identical to the one specified on t
loading port protected by fuses or circuit breaker conforming to local codes. THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
GROUNDING INSTRUCT
This appliance must be grounded. In
electric shock by providing a path of least resistance for electric current. The plug must be plugged into an
appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
WARNING:
Improper
with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly
grounded.
Do not mod
a qualified electrician.
e: if the electrical powe