Filter
Top Products
8
• The washing machine has stopped with water in
the tub, at the end of a programme with the
“Rinse Hold” or “Night Cycle”
option: this is indicated by a flashing zero. The
“Door” light will be lit and the door will be locked.
• The washing machine has completed the
programme: this is indicated by a flashing zero. The
zero will reappear when you switch the washing
machine on, unless the previous programme has been
erased by turning the programme selector dial to the
“O” Off position. The “Door” light will be off and
the door can be opened.
Important!
The first time you use the washing machine, when
you switch it on, it may display a flashing zero and give
an audible warning signal. This is due to the fact that the
washing machine has performed a washing cycle during
the manufacturer’s inspection tests, and this cycle has
not been erased after its completion.
• Delay start, a time value indicated in hours and
selected by means of the relevant button (max 23
hours).
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
0
After you have pressed the “Start/Pause” button, the
countdown begins, and the delay time value decreases
by one unit every hour and then, when 2 hours remain,
the time decreases in 30 minute intervals.
You can delay the start of the selected programme by
up to 23 hours in one hour intervals.
• An incorrect option selection has been made: this is
indicated by the message Err when a function
incompatible with the current programme is selected.
The incorrect selection is also indicated by an audible
warning signal.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 20).
8 “Delay Time” button
This button makes it possible to delay the starting of the
programme selected from 30 min - 60 min - 90 min, 2
hours and then by 1 hour up to a maximum of 23 hours.
The delay you have selected is shown on the display for
about 3 seconds; afterwards, the duration of the
programme reappears.
You must select this option after you have set the
programme and before you press the “Start/Pause”
button.
The time value shown on the display will decrease by
one unit every hour.
E20
132978490.qxd 22/09/2006 14.06 Pagina 8
Ofrecido por www.electromanuales.com