Filter
Top Products
15
Setting the delay timer
3 Using the DELAY TIMER button you can delay the start of a programme
by 30 minutes (30') to a maximum of 23 hours (23h).
1. Select the programme.
2. Press the DELAY TIMER button repeatedly until the desired start delay is
shown in the multi-display, e.g. 12h to delay the start of the pro-
gramme by 12 hours. The DELAY TIMER indicator will illuminate.
3 If the display is showing 23h and you press the button again, the time
delay will be cancelled. 0’ will appear followed by the length of the
wash programme that has been set.
3. To activate the delay timer, press the START/PAUSE button. The time re-
maining to the start of the programme will be continuously shown (e.g.
12h, 11h, 10h,... 30
' etc.).
Starting a programme
1. Check that the tap is turned on.
2. Select a programme.
3. Press the START/PAUSE button. The programme is started, or will start
after the delay timer has counted down.
3 If after pressing the START/PAUSE button E40 flashes in the multi-dis-
play, the END indicator flashes 4 times and at the same time an acous-
tic signal sounds 4 times, the door has not been correctly shut. Push the
door firmly closed and press the START/PAUSE button again.
Programme sequence
• The programme progress display shows the programme step that is
currently being carried out.
• The multi-display shows the estimated time remaining (in minutes)
until the end of the programme.
3 The time remaining can increase or stay the same for a while during the
course of the cycle as the programme adjusts itself to various condi-
tions (e.g. type of washing and quantity, out of balance spin detection,
special rinse cycle, etc.).