Filter
Top Products
Operating Instructions
31
What to do if...
Trouble Shooting
If the appliance is not working correctly, please carry out the following
checks before contacting your local AEG Service Force Centre.
Important: If you call out an engineer to a fault listed below, or to re-
pair a fault caused by incorrect use or installation, a charge will be
made even if the appliance is in guarantee.
• If the fault code C1, C2 or Cd is shown in the
multi-display, you may be able to remedy the
fault yourself (see the Faults table below).
When you have remedied the fault, press the
START/PAUSE button.
• With all other displayed faults (C plus number or letter): switch appli-
ance off and on again. Reset the wash programme and press the
START/PAUSE button.
If the fault code is displayed again, please contact the Customer Service
department quoting the fault code.
Problem Possible Cause Remedy
The washing machine
does not work.
The mains plug is not
plugged in.
Plug in the mains plug.
The house fuse has blown. Replace the fuse.
The door is not correctly
closed.
Close the door; The lock must
engage audibly.
START/PAUSE button not
pressed long enough.
Keep the START/PAUSE but-
ton pressed until the pro-
gramme begins.
Door cannot be closed. The child safety feature is set
Cancel the child safety fea-
ture (see Section "Child
Safety Feature“).
The fault code Cd ap-
pears. The displays PRE
WASH, RINSE and
RINSE+ are flashing.
The door is not correctly
closed.
Close the door correctly.
Start the programme again.