Filter
Top Products
Operating Instructions
23
Starting a wash programme
0 1. Ensure that the tap has been turned on.
2. Starting a wash programme: Press the START/PAUSE
button
The wash programme will start, or starts after the
countdown of the time delay set.
3
The door has not been shut properly if, when the START/PAUSE button
is pressed,
– the error code Cd appears in the multi-display,
– and the PRE WASH, RINSE and RINSE+ indicators are flashing,
Should this happen, press the door firmly closed and press the START/
PAUSE button once more.
if a time delay has been set:
The time delay set counts down, the time remaining to the start of the
programme (always in whole hours, e.g. 5h) will be shown in the multi-
display. During this time you can add additional washing or change or
cancel the delay timer.
• Adding washing: Press the START/PAUSE button; the door can be
opened. Then close the door and press the START/PAUSE button
again.
• Changing or cancelling the delay timer: Continue pressing the DELAY
TIMER button until the desired time is displayed; when the pro-
gramme length is displayed (display in minutes, e.g.120) the wash
programme will start straight away.