Filter
Top Products
Installation and Connection Instructions
49
Water Drainage
The appliance drain hose should hook into a standpipe, the hook in the
drain hose is formed using the plastic U-Piece supplied. The standpipe
should have an internal diameter of approximately 38 mm (see dia-
gram) thus ensuring there is an air break between the drain hose and
standpipe.
When discharging into a stand-
pipe ensure that the top of the
curve in the hose end is no more
than 90 cm (35.4) and no less
than 60 cm (23.6) above floor
level.
The upright standpipe should
have a minimum, length of
30 cm (12) from the bottom of
the elbow to the top of the pipe
(see diagram). Make sure that it
is designed in such a way that
the end of the drain hose can-
not be covered with water.
Longer drain hoses are availa-
ble in lengths of 2.7 and 4
metres from your AEG Service
Force Centre.
If you intend the drain hose
from the washing machine to
empty into a sink, make sure
that the sink is empty and the
plug hose is not blocked. Use
the plastic U-Piece supplied.
Min 60 cm (23,6)
Max 90 cm (35,4)
Min 30 cm (12)
38mm (1
1
/
2
)
diameter standpipe