Filter
Top Products
Operating Instructions
28
Excessive foaming
during the main wash.
Probably too much washing
powder was used.
It may be necessary to
reduce the amount of
detergent used. Follow the
detergent manufacturer´s
recommendations.
Water is leaking out
from under the wash-
ing machine.
The inlet hose connection is
not tight.
Tighten the inlet hose con-
nection.
The inlet hose has a leak.
Check the inlet hose and if
necessary replace it.
The drain pump cover is not
tight.
Tighten cover by turning
clockwise.
Washing is caught in the
door.
Stop the program, remove
the washing caught in the
door, start a new program.
Fabric softener is not
added, compartment
À
for fabric softener
is filled with water.
Suction cap in the fabric sof-
tener compartment is not
correctly fitted or is blocked.
Clean the detergent com-
partment, fit the suction cap
on firmly.
Appliance does not
spin, water in the
drum.
RINSE HOLD selected. Deselect RINSE HOLD.
SOAKING program is termi-
nated.
Pump out water and set the
main wash cycle as desired.
Washing has not been
spun sufficiently, there
is water left in the
drum.
There is a kink in the outlet
hose.
Remove the kink.
Drain hose is too high.
Check the installation
instructions.
Drain pump is blocked.
Switch off the machine and
pull the plug out of the
socket, clean the drain pump.
The water drainage system is
blocked.
Clean the blockage.
Door cannot be
opened.
The program has not yet
been completed.
Wait until ON/OFF indicator
goes out.
The rinse water is
cloudy.
Probably caused by a wash-
ing powder with a high sili-
cate content.
This does not affect the
rinse results. If necessary use
liquid detergent.
Fault Possible cause Remedy