16 electrolux use
Altering an option or a running
programme
It is possible to change any option
before the programme carries it out.
Before you make any change, you
must pause the washing machine by
pressing the Start/Pause button.
(Only the Time Manager option
cannot be modified after the
programme has started. )
Changing a running programme is
possible only by resetting it. Turn the
programme selector dial to O and then
to the new programme position. The
washing water in the tub will not be
emptied out.
Start the new programme by pressing
the Start/Pause button again.
Interrupting a programme
Press the Start/Pause button to
interrupt a programme which is
running, the corresponding light starts
to flash. Press the button again to
restart the programme.
Cancelling a programme
Turn the selector dial to O to cancel a
programme which is running. You can
now select a new programme.
Opening the door after the
programme has started
First set the machine to pause by
pressing the Start/Pause button.
If the «Door» pilot light goes off,
the door can be opened.
If the «Door» pilot light stays on,
this means that the machine is already
heating, that the water level is above
the bottom edge of the door or that
the drum is turning.
In this case the door can not be
opened.
If you cannot open the door but you
need to open it you have to switch the
machine off by turning the selector dial
to «O».
After about 3 minutes the door can be
opened (pay attention to the water
level and temperature!).
At the end of the programme
The machine stops automatically, the
Start/Pause light goes off and a
flashing “
0.00” will appear on the.
If the Rinse Hold” or Night Cycle
options have been selected, the
“Door” pilot light illuminates, a
flashing «
0.00» will appear on the
display, the Start/Pause light goes off
and the door remains locked to
indicate that the water must be
emptied out before opening the door.
To empty out the water please read
the steps on the Night Cycle option
paragraph.
Turn the programme selector dial to
«O» to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out
another wash, close the water tap.
Leave the door open to prevent the
formation of mildew and unpleasant
smells.
132972120 EN.qxd 26/10/2007 11.28 Pagina 16