Filter
Top Products
34 electrolux what to do if…
What to do if…
Remedying small malfunctions
If, during operation, the error code (E
plus number or letter) appears on the
multi-display: Switch the appliance off
and on again. Reset programme. Press
the START/PAUSE button.
If the error appears again, please con-
tact the Customer Care Department,
stating the error code.
Problem Possible cause Remedy
Washing machine does
not work.
Mains plug is not plugged in or
fuse is not working correctly.
Plug in at mains socket. Check
fuse in fuse box (domestic installa-
tion).
Door is open. Close door.
Press the START/PAUSE but-
ton.
Press the START/PAUSE button.
Drum light is not working.
Programme selector in O OFF
position.
Turn the programme selector to
any programme.
Defective light bulb.
Replace light bulb (see next sec-
tion).
Iron Aid programme does
not start.
Water tank is empty. Fill water tank.
After an Iron Aid pro-
gramme, garments are
not sufficiently smooth.
Wrong programme selected
(e.g.
SYNTHETICS instead
of
COTTON).
Note the composition of the fabric.
Too low a LOAD steam level
set.
Set a higher LOAD steam level.
Too many garments in machine,
or garments that are too differ-
ent.
Load the machine with fewer gar-
ments, or only similar ones.
Clothes are not removed until
the anti-crease phase is fin-
ished.
Remove clothes quickly one at a
time from the machine as soon as
possible after the start of the anti-
crease phase.
Garments not hung on clothes
hangers and/or not tugged into
shape.
Hang garments on clothes hang-
ers, do up buttons and tug gar-
ments into shape.
Multi-layered garments tend to
lose their shape.
Reshape multi-layered garments
by ironing after they come out of
the machine.
After an Iron Aid pro-
gramme, there are no
creases left in the gar-
ments.
The Iron Aid programme has
the effect of smoothing gar-
ments.
Iron creases in again after the Iron
Aid programme.