Filter
Top Products
starting a drying programme electrolux 27
Starting a drying programme
Press the START/PAUSE button. The
programme is started.
The programme progress display shows
drying progress. The symbols for
DRYING and COOLING appear in
the display one after the other. The
number of droplets in the dryness indi-
cator gradually goes down as the drying
process progresses.
Changing a programme
To change a programme which has
been selected by mistake once the pro-
gramme has started, first turn the pro-
gramme selector to OFF and then reset
the programme.
The programme can no longer be
changed directly once the pro-
gramme has started. If you never-
theless attempt to change the
programme with the programme
knob or an additional function but-
ton (except the BUZZER button), the
START/PAUSE button and Err will
flash in the multi-display. The drying
programme is not however affected
by this.
Removing laundry or loading
laundry when necessary
1. Open loading door
Warning! Laundry and drum can bec
ome hot. Risk of burns!
2. Load or remove laundry items.
3. Close the door securely. Lock must
audibly lock.
4. Press the START/PAUSE button to
continue the drying cycle.
Drying cycle complete / removing
laundry
Once the drying programme has fin-
ished, CREASE GUARD lights up in
the display. If the BUZZER is activat-
ed, an audible signal sounds at regular
intervals.
The drying cycle is automatically
followed by a anti-crease phase
which lasts around 30 minutes.
The drum rotates at intervals during this
phase. This keeps the laundry loose and
free of creases. It can be removed at any
time during the anti-crease phase. (The
laundry should be taken out towards the
end of the anti-crease phase at the lat-
est to prevent creases from forming.)
1. Open door.
2. Before removing the laundry, remove
fluff from the micro-fine filter. It is best
to use a damp hand for this purpose.
(See “Cleaning and maintenance”
section.)
3. Remove laundry.
4. Turn the programme knob to O OFF.
5. Important! After each drying cycle
– Clean the micro-fine filter and fine fil-
ter
– Drain the condensed water contain-
er
(See section “Cleaning and mainte-
nance”.)
6. Close door.