Filter
Top Products
Buzzer
When the drying cycle has finished, an inter-
mittent audible signal will sound. By depress-
ing button the acoustic signal is switched off
in the following cases:
• when selecting the programme
• when depressing the buttons
• when the programme selector dial is
turned to another position during the pro-
gramme or when you depress an option
button during the cycle
• at the end of the programme.
The corresponding light comes on.
Time
Use the TIME button to select the pro-
gramme duration after setting the TIME pro-
gramme. You can select a programme du-
ration from 20 min. to 3 hours in 10-minute
steps.
1. Turn the programme selector to the pro-
gramme.
2. Press the button repeatedly until the de-
sired programme duration is shown in the
display, e.g.
for a pro-
gramme of 20 minutes.
If the programme duration is not selected,
the duration is automatically set to 10 mins.
Delay start
With the DELAY button, you can delay
the start of a programme by between 30
minutes (30') and a maximum of 20
hours (20h).
1. Select the programme and additional
functions.
2. Press the Delay button as many times as
necessary until the required time of the
delay appears on the display, e.g.
H if the programme is to be started in 12
hours.
If the display is showing H and
you press the button again, the time de-
lay will be cancelled. The display will
show 0 and then the duration of the se-
lected programme.
3. To activate the delay timer, press the
Start/Pause button. The amount of time
remaining until the programme is set to
start is continuously displayed (e.g. 15h,
14h, 13h, … 30' etc).
Setting child lock
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child lock function locks all
buttons and the programme knob. The child
lock can be activated or deactivated by hold-
ing down the BUZZER and TIME buttons si-
multaneously for 5 seconds.
– Before programme is started: Appli-
ance cannot be used
– After programme is started: Pro-
gramme in operation cannot be
changed
The
icon appears in the display to indicate
that the child safety device is activated.
The child safety device is not deactivated
once the programme comes to an end.
If you want to set a new programme, you
must first deactivate the child safety device.
Starting the programme
Press the START / PAUSE button. The pro-
gramme is started.
The programme phase is shown in display by
appropriate icons. From left to the right, from
drying
,anticrease , to cooling .
Changing programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
" O" (OFF) position. The programme is can-
celled.
The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob or if an function
button (excluding the button) is pressed,
led above START/PAUSE button starts
flashing temporarily in yellow. The drying
programme is not however affected by
this (laundry protection).
Drying cycle complete / removing
laundry
Once the drying cycle is complete, display
shows a blinking " 0 ", under anti-crease
and filter icon appear dash. If the (Buzzer)
electrolux 9