Filter
Top Products
Cleaning the door
Clean periodically the interior part of the door
to remove any fluff. Accurate cleaning en-
sures correct drying.
Cleaning the drum
Caution! Do not use abrasives or steel
wool to clean the drum.
Lime in the water or cleaning agents may
form a barely visible lining on the inside
of the drum. The degree to which the
laundry has been dried is then no longer
detected reliably. The laundry is damper
than expected when removed from the
dryer.
Use a standard domestic cleaner (e.g.
vinegar-based cleaner) to wipe down the
inside of the drum and drum ribs.
Clean operating screen and housing
Caution! Do not use furniture cleaners
or aggressive cleaning agents to clean
the machine.
Use a damp cloth to wipe down the op-
erating screen and housing.
What to do if ...
Troubleshooting by yourself
If, during operation, the error code E... plus
number or letter) appears on the LCD: Switch
the machine off and on again. Reset pro-
gramme. Press the START / PAUSE button
If the error is still displayed, please inform
your local Service Force Centre and quote
the error code.
Problem Possible cause Remedy
Dryer does not work.
Mains plug is not plugged in or
fuse is not working correctly.
Plug in at mains socket. Check
fuse in fuse box (domestic in-
stallation).
Loading door is open. Close loading door.
Have you pressed the START /
PAUSE button?
Press the START / PAUSE but-
ton again.
Drying results unsatisfactory.
Wrong programme selected.
Select a different programme
the next time you dry (see “Pro-
gramme chart” chapter).
Filter clogged. Clean filter.
Overloading of laundry.
Observe recommended loading
volumes.
Ventilation slots covered up. Uncover ventilation slots.
Residue on inside surface of
drum or drum ribs.
Clean inside surface of drum
and drum ribs.
Conductance of water at instal-
lation site differs from standard
setting of machine.
Re-programme standard setting
for degree of drying (see ‘Pro-
gramming options’ chapter).
Loading door does not close. Filter not in place. Install filter into place.
When a button is pressed, Err
appears on the LCD.
Washing protection. After the
start of the programme, the op-
tion can no longer be set.
Turn the programme knob to
"O" (OFF) . Set the programme
again.
Drum light does not work.
Programme selector in "O"
(OFF) position.
Turn programme selector to any
programme.
Defective light bulb.
Replace light bulb (see next sec-
tion).
electrolux 11