Filter
Top Products
Select an additional rinse (EXTRA RINSE)
This appliance is designed for saving water. However, for people with a very delicate skin
(allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of
water.
Press simultaneously buttons 2 and 3 for some seconds: the pilot light 10.2 comes on. This
function stays permanently on. To remove it press the same buttons again until the pilot
light 10.2 goes off.
Select the START/PAUSE (Button 8)
To start the selected programme, press the button 8, the corresponding red pilot light stops
blinking.
The symbols 7.4 and 7.5 appear on the display to indicate that the appliance starts operat-
ing and that the door is locked.
To interrupt a programme which is running, press the button 8: the corresponding red pilot
light starts blinking.
To restart the programme from the point at which it was interrupted, press the button 8
again. If you have chosen a delayed start with button 9, the machine will begin the count-
down. If an incorrect option is selected, the yellow pilot light of the button 8 blinks for 3
times the message Err is displayed for about a few seconds.
Select the DELAY START (Button 9)
Before you start the programme, if you wish to delay the start, press the button repeat-
edly, to select the desired delay.
The selected delay time value (up to 20 hours) will appear on the display for a few seconds,
then the duration of the programme will appear again.
You must select this option after you have set the programme and before you press the
button 8.
The wash programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1
hour up to a maximum of 20 hours by means of this button.
The door will be locked throughout the delay time. If you wish to add laundry in the ma-
chine during the delay time you will press button 8 to put the machine in pause. Add the
laundry, close the door and press button 8 again.
Selecting the delayed start.
• Select the programme and the required options.
• Select the delay start.
• Press button 8: the appliance starts its hourly countdown. The programme will start after
the selected delay has expired.
Cancelling the delayed start
• Set the washing machine to PAUSE by pressing the button 8;
• Press button 9 once until the symbol
’ is displayed;
• Press the button 8 again to start the programme.
The selected delay can be changed only after selecting the washing programme again.
The Delay Start can not be selected with the draining programme.
Daily use
13