Filter
Top Products
27
3.Remove both plastic caps sideways.
3 Special spanner A and sealing caps B
(2 off) and C (1 off) are supplied
with the appliance.
4.Remove screw D with its compres-
sion spring using special spanner A.
5.Turn sealing cap C upside down as
shown in the illustration.
6.Seal hole using sealing cap C.
7.Unscrew and remove two screws E
using special spanner A.
8.Unscrew and remove four screws F
using special spanner A.
9.Remove transit bar G.
10. Screw in the four screws F again.
11. Seal the two big holes using sealing
caps B.
Important! Press all sealing caps B
(2 off) and C (1 off) in firmly, so that
they snap into place. (Splash protec-
tion).
Where to install
Important! The appliance must not be used in a room where there is a
danger of frost. Frost damage or impaired operation! Frost damage is
not covered by the warranty.
• The surface on which the appliance is to be installed must be firm
and level. Do not install the appliance on carpets or on soft floor cov-
erings.