Filter
Top Products
Permanent connection
In the case of permanent connection it is necessary that you install a double pole
switch between the appliance and the electricity supply (mains), with a minimum
gap of 3mm between the switch contacts and of a type suitable for the required
load in compliance with the current electrical regulations.
The switch must not break the yellow and green earth cable at any point.
Changing door stop
WARNING!
The door stop may only be changed by a specialist. If necessary, please contact our
after-sales service or your specialist dealer.
WARNING!
Before changing the door stop, disconnect the mains plug.
1. Open loading door.
2.
Unscrew hinge A from the front of the
machine and take off the loading door.
3.
Remove cover plates B and C. To do this,
insert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block D from
the snap-on fixture, take out and re-in-
sert on the other side having rotated the
block through 180°.
5.
Unscrew hinge A from the loading door,
rotate through 180°, re-insert on the
opposite side and screw down.
6.
Re-insert cover plates B and C on the opposite site having first rotated them
through 180°.
AC
C
D
A
B
Installation
37