Filter
Top Products
14
Changing programme
To change a programme which has been selected by mistake once the
programme has started, first turn the programme selector to OFF and
then reset the programme.
3 The programme can no longer be changed directly once the programme
has started. If nevertheless there is an attempt to change the pro-
gramme on the programme knob, the programme progress display and
the maintenance indicators flash. If an option button (excluding the
AUDIBLE SIGNAL button) is pressed, the corresponding indicator flashes
several times. The drying programme is not however affected by this
(laundry protection).
Removing laundry or loading laundry when necessary
1.Open loading door
1 Warning! Laundry and drum can become hot. Risk of burns!
2.Load or remove laundry items.
3.Close the door securely. Lock must audibly lock.
4.Press the START/PAUSE button to continue the drying cycle.
Drying cycle complete / removing laundry
Once the drying cycle is complete, the END and CREASE GUARD dis-
plays light up. If the AUDIBLE SIGNAL button has been pressed, an au-
dible signal sounds intermittently.
3 The drying cycle is automatically followed by a crease guard phase
which lasts around 30 minutes. The drum rotates in intervals during
this phase. The laundry thereby remains relaxed and free of creases. The
laundry can be removed at any time during the crease guard phase.
(The laundry should be taken out towards the end of the crease guard
phase at the latest to prevent creases from forming.)
1.Open loading door
2.Before removing the laundry, remove lint from the micro-fine filter. It is
best to use a damp hand for this purpose (refer to “Cleaning and main-
tenance” section).
3.Remove laundry.
4.Turn the programme selector to OFF.
Important! After each drying cycle
– clean the micro-fine filter and fine strainer,
– drain the condensate tank
(refer to the “Cleaning and maintenance” section).
5.Close loading door.