Filter
Top Products
Operating Instructions
23
Washing cycle complete/removing the washing
Once a washing programme cycle has come to an end, L (END) illumi-
nates on the Programme Progress Display.
If o (RINSE HOLD) was selected, the indicator lights beside
K
(DOOR)
and L (END) come on.
0 1. After a Rinse Hold, the water must first be drained:
– Either turn the programme selector to I (OFF), then turn to
v (DRAIN) and press the O/s (START/PAUSE) button
(the water is drained without spinning),
or
– turn the programme selector to I (OFF), then turn to K (SPIN) and
press the O/s (START/PAUSE) button
(the water is drained and the washing given a spin. The spin speed
can also be changed during the spin cycle).
When this stage of the programme is completed, the L (END) light
comes on.
2. Open the door.
The door can be opened after the
K
(DOOR) light goes off and the
L (END) light has come on.
3. Remove the washing.
4. Turn the programme selector to I (OFF).
5. Close the water tap.
6. After the washing cycle is completed, pull out the detergent dispenser
drawer slightly, to allow it to dry. Leave the door slightly open, to air
the inside of the washing machine.
Important! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains.