Filter
Top Products
Setting up and connection instructions
44
Setting up and connection instructions
Safety Instructions for Installation
• Do not tilt the washing machine onto its front or onto its right side
(looking from the front). Electrical components could get wet!
• Check the washing machine for transport damage. Never connect a
damaged unit. Consult your supplier in the event of damage.
• Ensure that all parts of the transport safeguard have been removed
and that the splash guard is fitted to the unit, see ”Removing the
Transport Safeguard”. Otherwise, damage to the unit or to adjacent
furniture could occur during spinning.
• Always insert the plug into a correctly installed PE socket.
• In the case of permanent installation: A permanent installation may
only be made by an authorised specialist.
• Before putting the unit into operation, ensure that the rated voltage
and current type shown on the unit's rating plate are the same as the
mains voltage and current type at the installation location. The re-
quired electrical fuse is also shown on the rating plate.
• Should work be carried out on the water supply installations in order
to allow the machine to be connected properly to the water supply,
this work must be carried out by an authorised installer.
• Should work be carried out on the mains supply in order to allow the
machine to be connected properly to the electricity supply, this work
must be carried out by an authorised electrician.
• The mains cable may only be replaced by the Customer Service or by
an authorised specialist.