Filter
Top Products
Instructions for use
35
No water runs in.
Fault code
E10
appears. The indicator
RINSE+ (SPÜLEN+,
RINCAGE+) flashes.
Water valve is closed. Open the water valve.
Filter in screw connection of
the intake hose is blocked.
Close the water valve.
Unscrew the hose from the
water valve, remove the filter
and clean it under running
water.
Water tap is blocked with
limescale or is faulty.
Check water tap and have it
repaired if necessary.
The washing machine
vibrates during opera-
tion or it is on an
uneven surface.
The transport safeguard has
not been removed.
Remove transport safeguard
as indicated in the instruc-
tions for installation and
connection.
The height-adjustable screw
feet are not correctly set.
Adjust in accordance with
the installation and connec-
tion instructions.
There is not much washing in
the drum (e.g. only one
dressing gown).
This does not impair the
operation of the machine.
The water could not be com-
pletely pumped off before
spinning because the drain-
age hose is bent
or
the solution pump is blocked.
Check the laying of the
drainage hose and eliminate
the bend if necessary, or
clean the solution pump and,
if required, remove foreign
bodies from the pump hous-
ing.
The washing solution
of the main wash
froths up a lot.
Too much detergent was
probably used.
Meter the detergent exactly
in accordance with the
manufacturer's information.
Problem Possible Cause Remedy