Filter
Top Products
Something not working?
If during the spin cycle the machine makes an unusual
whistling noise, different from the noise made by tradi-
tional washing machines, this is due to a new type of
motor.
If water is not visible in the drum, this is due to
the modern technology of new washing
machines that use less water than traditional
machines.
Troubleshooting
If a problem arises, you can try to solve it yourself following the
instructions below.
If you call out an engineer when one of the following problems arises,
or to repair a fault due to incorrect use, the call-out will be charged
even if requested within the guarantee period.
During machine operation the following alarm codes may be displayed:
- E10: problem with the water supply (phase light RINSE HOLD is on)
- E20: problem with water draining (phase light RINSES is on)
- E40: door open (phase light WASH is on)
Once the problem has been eliminated, press the START/PAUSE button
to restart the programme. If after all checks, the problem persists, con-
tact your local AEG Service Force Centre.
31
Problem
The machine does not work
Possible cause
The ON/OFF button Depress the button.
has not been depressed.
The main electrical fuse Replace the fuse.
has blown.
The door is not properly Close the door; the click
closed (E40). of the lock should be heard.
The plug is not connected Insert the plug or replace
or the fuse in the plug has the fuse.
blown.
The START/PAUSE button Press the button.
has not been pressed.
The DELAY START Check the selected delay on
option has been selected. the display.
Solution
132992080.qxd 5/22/03 5:02 PM Pagina 31