Filter
Top Products
Cancelling/Altering a programme
To cancel or alter a programme which is running, turn the programme
selector dial to the RESET position: three flashing dashes will be dis-
played, the programme is cancelled. The machine will maintain the
water in the tub. To drain water, select DRAIN programme. If you wish
to select another programme maintaining the water in the tub, after
cancelling the previously selected programme select a new one and
then start it by pressing START/PAUSE button.
Opening the door after the programme has started
You can open the door, after having set the machine to PAUSE, provid-
ed the following conditions exist:
• the machine is not in the heating phase beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the machine the door
can be opened.
Should it not be possible to open the door, and should it be absolutely
necessary to do so, switch the machine off by pressing the ON/OFF but-
ton.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of the water in the
machine!
When you close the door and press the ON/OFF button again, the
machine will resume the programme from the point where it had been
interrupted.
16
Description of the appliance
132992080.qxd 5/22/03 5:01 PM Pagina 16