Filter
Top Products
11
Operating Instructions
6. Select the appropriate cycle and
settings for the load.
Turn the cycle selector knob in either direction
to select the cycle desired. The indicator for
that cycle will be illuminated. See the “Cycle
Selection” section in this guide for descrip-
tions of each cycle.
The estimated cycle time, suitable wash and
rinse water temperatures, fi nal spin speed, soil
level, and options for each cycle will be indi-
cated for the cycle selected. See the “Cycle
Settings” and “Washer Settings Chart” in this
guide for descriptions and available settings
for each cycle.
To change the settings, press the tempera-
ture, spin speed, soil, and options buttons to
scroll to the desired settings.
To select or delete an option, press the button
for that option. The indicator will light when
the option has been selected. It will no longer
be lighted when the option has been deleted.
As a safety measure, the door will automati-
cally lock during the entire wash cycle.
To add a forgotten item to the washer any time
during the wash portion of the cycle, press
pause. When the door unlocks, open the door,
add the item, close the door and press start to
resume the cycle.
If changes to the settings or options are at-
tempted after the cycle starts, you will hear
several beeps when the buttons are pressed.
To change the settings or options, press pause,
make the new selections and press start again.
To change the cycle once the cycle has begun,
press cancel, select a new cycle, and press
start again. Just turning the cycle selector
knob will not change the cycle.
To stop the cycle, press cancel.
NOTE
To provide the best care for your laundry, not
every setting or option is available with every
cycle. If a setting or option is not available for the
cycle selected, the indicator will not light.
NOTE
If the cycle is interrupted during spin, the door
lock will not release until the tub has stopped
spinning. DO NOT force open the door.
Adjustments to a cycle will be remembered
and recalled each time that cycle is selected in
the future.
A signal will sound at the end of the cycle if the
chime option has been selected.
Remove items from the washer when the cycle
ends and place in dryer, line dry or dry fl at as
directed on the fabric care label.
Follow the fabric care label instructions
on items to be washed.
For best results
OPERATING YOUR WASHER, continued
CAUTION
ENTRAPMENT and TIP-OVER HAZARD
An open door could entice children to hang on
the door or crawl inside the washer. If there are
no small children present, you may leave the
door ajar to prevent mildew and odor build up.
Excess wrinkling, color transfer or odors may
develop in items left in the washer after the
cycle has ended, if not removed promptly.
To return to factory settings,
press these two buttons at the
same time and hold until the
signal sounds.
7. Start the washer.
Close the door and press start. The washer
will not operate with the door open and DOOR
OPEN will be displayed.
Select delay start to delay the beginning of
the cycle for up to 22 hours if desired.