Filter
Top Products
HELPFUL HINTS
• Make sure that the vertical surface or wall is capable of supporting a fully loaded
dryer—approximately 45 kg.
• Leave a minimum clearance of 15mm. above the dryer so that it may be lifted on and
off the brackets easily.
• If you wish to mount the dryer above a top loading washing machine, leave enough
space below the dryer to open and close the lid.
Note:
• You can position the exhaust air vent at the back of the machine to remove air
upwards or sideways. See diagram.
• Remove the two screws and place the exhaust vent in the new position. Align the
holes with the dimples as shown and replace the screws.
• Do not attempt to lift or lower the dryer by yourself as it may slip and cause damage
rather get someone to help you.
ELECTRICAL INSTALLATION
• The dryer is designed to operate on a 230 volt, 50 Hz, 15 Amp, AC power supply.
• The machine should be connected to an earthed 3 pin wall socket.
• If the power cord should ever need replacing, use only a genuine cord available from
the nearest Defy Service Centre.
• Do not use double adaptors, extension cords or portable electrical outlets due to the
hazards associated with water splashes and moisture ingress.
The appliance must be earthed and the manufacturer and seller do not
accept responsibility for any damage due to incorrect electrical connection.