Filter
Top Products
INSTALLATION
UNPACKING
• Remove all packaging and dispose of it in a responsible manner.
• Open the wash-tub lid and remove all the accessories stored in the drum.
• Do not attempt to operate the machine while any of the packaging is still in place.
POSITIONING
• The machine should be installed in a well
ventilated place, away from direct sunlight.
• Hot and cold water taps should be located
within 1 metre of the inlet valves.
• Position the machine on a flat and stable
uncarpeted floor capable of supporting the fully
loaded washer.
Adjustable levelling feet are located at the front of
the machine and may be turned in or out to achieve
stability. An unstable machine will vibrate and
generate excessive noise.
DRAIN HOSE
• Connect the drain hose to the drain outlet at the
rear of the machine and secure it with the hose
clamp supplied.
• Hook the outlet end of the drain hose over the
lip of a sink or outlet pipe.
Drain hose
Hose clamp
Drain
outlet
SINK OR LAUNDRY TUB DRAIN
• The top lip of the sink must be at least 860mm
(A) above floor level and not higher than
1300mm.
A