Filter
Top Products
TROUBLE SHOOTING GUIDES
Most problems are easily solved if you understand the cause. Check the following list for problem
befor calling for service.
Before calling for service, check these
18
• The washer will not spin;
• The washer will not
operate at all.
NOTE!
Please check the point before calling for a service.
If the supply cord is damaged, it must only be replaced by a repair shop appointed by
manufacturer, because special purpose tools are required.
• Is there a power failure?
• Is the power cord correctly connected to an electric outlet?
• Is the electric fuse broken?
• Did you turn on the power?
• Did you press Start/Hold button?
• Is there correct amount of water in the tub?
• Did you connect the inlet hose and open the water tap?
• Is the inlet hose or the water tap frozen?
• Is the water supply shut off?
• Does foreign matter block up the inlet hose filter?
• Is the drain hose frozen or blocked up by dirt?
• Is the drain hose kinked or deformed?
• Is the end of the drain hose immersed in water?
• Is there excessive dirt inside the pump housing?
• The washer will not drain;
If the drain is not finished within selected
time, lamp will light up, and the buzzer
will sound to indicate a problem.
• Water is not supplied;
If water supply is not finished within 30
minutes, the lamp will light up, and the
buzzer will sound to indicate a problem.
If the clothes is collected on one side during
spin and the tub becomes unbalanced, the
spin operation will be interrupted, and then
this unbalanced condition will be corrected
by following operation: WATER SUPPLY →
RINSE→ DRAIN However if the
unbalanced condition is unchanged despite
repeating the above operation, the lamp
will light up, and the buzzer will sound
to indicate a problem.
• Is the clothe in the tub collected on one side?
• Is the washing machine installed on an uneven floor or is the
vibration serious?
• Is the lid open?
(The lamp will light up in this case.)
• These cases are not malfunctions
• The sound “wing” heard during water supply is the operating sound made by the water inlet
valve.
• The sound “sha” heard in stopping the tub is the sound that comes from the autobalancer of
the tub.
• The sound “wung” heard during wash or spin is the operating sound made by the air bubble
generator.
PROBLEM CHECK POINT