Filter
Top Products
E-22
Guide for other useful programs
NOTE
• If you want to check the selected program, press the ‘Start/Pause' button again.
• Preparing washing before starting 'Time Delay';
- Turn on the water tap.
- Load laundry and close Door.
- Place the detergent and fabric softner in the detergent case.
• The actual time of finishing is a little different with your selecting time because of water supply condition and
selected water temperature,....
• 'DELICATE', 'Quick 20', 'Tub Clean' and 'Drain' program are not selected with 'Time Delay'.
• Adding clothes during 'Time Delay' operation is not allowed.
1
Put the laundry into the Drum and put the detergent and softerner into the detergent
case.
Then close the Door.
• Put the detergent into the main wash room(I I marking) and prewash room(I marking)
in the detergent case.
• Softener should be below
‘
MAX' level.
• Put the detergent into the pre wash room(I marking) only if you want to add prewash.
• When you want to use bleach, put it into the main wash room (I I marking) with
detergent.
2
Press the Power button.
• The LED shows only
‘
- --' signal.
3
Select the program by press the Delay Start button.
• If you press
‘
Start/Pause' button aftrer pressing Power button without selecting
program, the
‘
NORMAL' program is selected as default program.
• Select the
‘
Washing course' and
‘
Spin speed' and 'water temperature' by pressing
each corresponding button.
• The
‘
Time Delay' LED is to be lighting.
• Select the time delay time you want from 1 hour to 12 hours by pressing button.
• The displayed time shows program finishing time.
4
Press the 'Start/Pause' button.
• If you make this program successfully, only 'Time Delay' and 'Lock' LED are lighting.
* DELAY START(RESERVED WASHING)