Filter
Top Products
Toaddfueltoengine:
• Clean area around fuel cap, remove cap.
• Add regular unleaded gasoline, slowly,to the fuel
tank.
Important: Never mix oilwith gasoline.
• Installfuel cap and wipe up any spilledgasoline.
TO START THE CLEANING SYSTEM
The best way to start your cleaning system engine for
the first time is to follow these instructionsstep-by-
step. This starting information also applies whenever
you start the engine after you have let the cleaning
system sit idle for at least a day.
• Place the cleaning system in an area close enough
to an outside water source that can flow at ;_rate of
at least 3 gallons per minute. Connect a garden
hose to the water spout.
• Check that the high pressure hose istightly
connected to the spray gun and to the pump. See
ASSEMBLY section on page/4.
• Check inlet screen on the water inlet. If the screen
isdirty, clean before attaching a garden hose. Ifthe
screen is damaged, do not connectto the garden
hose. Replace with screen provided in maintenance
kitor call 1-800-366-PART to order a replacement
inletscreen.
• Attach the the garden hose to the water inlet.
• Tum on the water.
Important: Do not run pump without the water supply
connected and turned on. You mustfollow this
caution or the pump will be damaged.
• Remove the adjustable nozzle extension from the
spray gun.
• Pullthe trigger on the spray gun and hold until a
steady stream of water appears.
• Engage the safety latch on the spray gun.
Safety Latch
• Attach adjustable nozzle extension onto spray gun.
• Pull choke lever all the way out to the =FULL
CHOKE POSITION."
Choke Lever
in =Full Choke
Position"
Note: If restarting a warm engine after a short
shutdown, move choke lever to =NO CHOKE
PosmoN."
• Move Run/Stop switch to the "1" or on position.
8