Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Safety Information
AJ1031
6
12. Replace worn power cords and/or loose plugs.
13. Never operate the press with any guards
and/or panels removed.
14. DO NOT operate the press with missing or
broken parts.
15. DO NOT bypass any safety devices.
16. Failure to install, maintain, and/or operate this
press according to the manufacturer’s
instructions may result in conditions which can
produce bodily injury and/or property damage.
NOTE: The WARNINGS and IMPORTANT
SAFETY INSTRUCTIONS appearing in this
manual are not meant to cover all possible
conditions and situations that may occur. Common
sense, caution and care must be exercised when
installing, maintaining, or operating the press.
Any problems or conditions not understood should be
reported to the dealer, distributor, service agent or the
manufacturer.
When using your press (garment finishing appliance),
basic precautions should always be followed,
including the following:
1. Read all instructions.
2. Use appliance only for its intended use.
3. Close supervision is necessary for any appliances
being used by or near children. Do not leave
appliance unattended while connected.
4. To reduce the likelihood of circuit overload, do
not operate another high wattage appliance on the
same circuit.
Safety signs and labels are also placed on the press.
Those signs and labels are limited messages. Where
needed, further explanations are provided in the
manual. These signs are to be inspected for readability
and replaced when missing, damaged or unreadable.
Refer to Operation/Maintenance Manual for
inspections process. Refer to parts manual for ordering
information.
To avoid possible serious injury, ensure
that air and steam supply systems have
adequate RELIEF VALVE PROTECTION or
have the pressures sufficiently limited at
the sources for safe operating pressures
as specified for this equipment.
W333
DANGER
To AVOID possible serious injury, BEFORE
performing maintenance or repair tasks:
• Shut off and lock out ALL electric power
to the press.
• Shut off and lock out ALL air service to
the press.
• Shut off and lock out ALL steam service
to the press.
• Allow heated surfaces to cool.
W358
WARNING
• Failure to install, maintain, and/or operate this machine according to the manufacturer’s
instructions may result in conditions which can produce serious injury, death, and/or
property damage.
• Do not repair or replace any part of the machine or attempt any servicing unless specifically
recommended or published in the service manual and that you understand and have the
skills to carry out.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded and to reduce the risk of fire,
electric shock, serious injury, or death.
W335
WARNING