Filter
Top Products
24
4
B
A
Cool down
This function allows to gradually lower the temperature of the wash bath to
prevent creasing of the linen.
During a cool down, the remaining program time on the central display will
be replaced by “cd”.
Power Failure
Should the power fall out during the program, the water will be drained and the
door can be opened after maximum 3 minutes. When the door remains locked,
and the power comes back up within 24 hours, the program will continue from
there, where it was at the time of the power failure.
If due to breakdown, the door is not unlocked automatically, you have to re-
move the service panel (A) below and pull the ring (B), suspended on the left
side, while opening the door.
Important:
Central panel control (Option)
Here payment is done through the central panel and not directly into the
machine. As soon as the payment is done, and a machine has been selected
normally, “STA” appears blinking on the left display. The machine can be
started by pressing the START button or the special START button, which
has been built in on the spot of the coin meter (option).
Remark :
Before opening the door, check that all the water has been drained from
the tub and that the cylinder has come to a complete stop.
This option can only be used, when it has actually been programmed as such
in the programmation.(REMOTE START).
For certain versions, PAY can appear on the left display when this operation
is not active.
Therefore, “Remote PAY” was programmed in the programmation.