Filter
Top Products
23
4
At the end of a program, while the door is being released, the left display shows
End and the Start-LED is switched off. After that only the right display will
continue to show the program number. This is the end of the program.
End of a program
Rapid advance
This function allows to skip the rest or certain segments of the program. This
function has to be specifi ed during preprogramming and is mostly used by
technicians and maintenance personnel.
Selection
Push the SELECT-button (P) at the time the special
function needs to be activated and keep the button depressed.
Now push the upper hidden button simultaneously and release same. Only
now release the SELECT-button (P).
The central display now shows F5 and this function is now active.
Operation
By pressing and releasing the lower hidden but-
ton and releasing it again, the programs skips to the next seg-
ment (if necessary, the program can be advanced to the end).
To return to the original wash program, press the upper hidden button.
Attention!
If F5 is activated during fi nal spin, this segment of the program will be skip-
ped as described above. It is however followed by a coast and tumble time to
disentangle the linen. This special function prevents the user from opening
the machine while the drum is still rotating and represents an important safety
feature.
Premature ending of the program
By using the rapid advance function during the program, a program can be
prematurely ended. When the end of a program is reached using this function,
and as long as the water has not reached the safety level, the door will remain
sealed and the display will show “SLE” (Safety Level) on the left display.
Afterwards the display will temporarily show “End” on the same display.
After that only the right display will continue to show the program number.
This is the end of the program.
Remarks
Hidden buttons
If any attempt is made to interrupt the program prematurely during a
spin phase of the program, all functions on the display will be temperary
replaced by blinking horizontal dashes. After that only the right display
will continue to show the program number and the door will be released.
This is the end of the program.
Remark: