Filter
Top Products
SKU 98332 For technical questions, please call 1-800-444-3353. Page 10
Appropriate brushes, grips, rags, 5.
etc. should be provided for effective
cleaning.
Safe disposal must be provided for 6.
any rags or other materials used in
the cleaning process.
General Operating Instructions
1.
Parts Washer to open.
Check to be sure Drain Plug (11) and 2.
associated O-Ring (10) are secure to
prevent leaks.
Pour in up to 20 Gallons of approved 3.
Plug the Electric Cord (19) into an ap-4.
propriate power source.
5.
Flexible Pipe (24) into the Tub area of
the Body (7).
Press the Switch (23) to the ON 6.
position. The Pump (30) will operate,
circulating solvent through the Flex-
ible Pipe (24).
To clean parts, you may use the sol-7.
vent in the tub portion of the Body (7)
or spray solvent directly on the parts
using the Flexible Pipe (24).
The Work Shelf (6) and Work Basket 8.
(2) may be used to soak, support or
drain parts during the cleaning pro-
cess.
When work is completed, press the 9.
Switch (23) to the OFF position.
Remove cleaned parts.10.
Shut the Cover (1).11.
To prevent accidents, turn off the tool 12.
and disconnect its power supply after
use. Clean, then store the tool in-
doors out of children’s reach.
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE:
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Cleaning, Maintenance, and
Lubrication
BEFORE EACH USE,1. inspect the
general condition of the tool. Check
for leaks, loose screws, misalignment
or binding of moving parts, cracked or
broken parts, damaged electrical wir-
ing, and any other condition that may
affect its safe operation.