Filter
Top Products
Q-Wash 260-LED QRG
Page 6 of 10
Menu Options
1
st
Level Programming Levels Description
INTRO
ADDRESS
001~512
Selects a starting DMX address
RESET
NO/YES
Resets the
p
roduct’s custom settings
FANS
HIGH
Select the fan’s operation mode.
NOTE: Fixture’s controller will force the fan to High if the
product’s internal temperature becomes too high, despite any
manual or DMX setting
NORMAL
LOW
AUTO
RUN
DMX512
Selects DMX running mode
AUTO1
Selects the first automatic program
AUTO2
Selects the second automatic program
CUSTOM
Selects the user customizable program
SOUND1
Selects the first sound program
SOUND2
Selects the second sound program
SLAVE
Selects the Slave running mode
TEST
Starts the product’s test sequence
CHANNELS
BASIC
Selects the 9-channel DMX mode
ADVANCED
Selects the 12-channel DMX mode
DISPLAY
60 CLOSE
Turns off the display after 60 seconds
BRIGHT
Keeps the display on
KEYLOCK
NO/YES
Activates/deactivates the control panel password
DIMMER
DIMMER 4~1
Slow (DIM 4) to fast (DIM1) dimmer curves
DIMMER 0
Linear dimmer
INFO
EDITION
Shows the version of the installed S/W
INVERT
PAN
NORMAL/
REVERSE
Defines the pan direction
TILT
Defines the tilt direction
DIMMER
Defines the direction of the dimmer fader
USE
NO/YES Activates the changes
RANGE
P/START
000~255
Sets the pan start point (restricted range)
P/FINISH
Sets the pan end point (restricted range)
T/START
Sets the tilt start point (restricted range)
T/FINISH
Sets the tilt end point (restricted range)
USE
Activates the changes
SPECIAL
BLACKD
NO/YES
Activates the move-in black delay (3 s)
RESET
DMX
The DMX controller can reset the product
SYSTEM
The control panel can reset the product
POWER
NORMAL/
HIGH
LEDs illuminate at normal or high intensity
NOTE: The product will return to Normal if the internal
temperature becomes too high
COLOR
UC
White output matches that of older products
RGBTOW
White output set by RGB-W
OFF
White output defined by RGBW faders
FAN
DMX
The DMX controller can set the fan speed
SYSTEM
The control panel can reset the fan speed
DMXERROR
SAVE
In case of lost DMX signal, the product will remain in its current
state
BLAK
In case of lost DMX signal, the product will blackout
EDIT
STEP
000~255
Selects the program step
PAN
Selects the pan position
TILT
Selects the tilt position
SPEED
Selects the pan/tilt spee
d
1st Level Programming Levels Description
EDIT (Cont.)
RED
000~255
Combines red, green, blue, and white to obtain a custom color
GREEN
BLUE
D
IMMER
Selects the dimmer value
STROBE
Selects the strobe frequency and mode
DIMSPEED
Selects the dimmer speed
TIME
Selects the step duration
USE NO/YES
Activates the changes
E
XTRA PASSWORD
****
Opens the Extra menu (see below)