Filter
Top Products
9
Express® Deck Lavatory System EXD-Series
Installation Instructions EXD-2N
Bradley Corporation • 215-1542 Rev. E; EN 06-915 2/9/07
Installation Instructions continued . . .
Step 5: Optional hot water heater
WARNING: To avoid personal injury or damage to the unit when installing the water
heater, make all plumbing connections first, then proceed with the
electrical connections.
NOTE: 240/208 or 277 voltage is required
for hot water heater. Refer to the
installation manual provided with the hot
water heater for further installation
information.
1. Remove the cover from the water
heater. Attach the bracket to the cover
with the two screws, nuts and
washers, then reattach the cover (see
Figure 6a).
2. Hang the water heater on the right
side frame member (see Figure 6b).
3. Connect the 1/2" flexible hose from
the cold water supply stub-out to the
hot water heater inlet.
4. Connect the 1/2" flexible hose from
the hot water heater outlet to the
supply inlet on the solenoid valve
assembly.
Step 6: Completing installation
1. Install the faucets according to the
installation instructions that came
with your faucets.
2. Turn on the water supply to the
Express® Deck and check for
leaks.
3. FOR DECKS WITH INFRARED
FAUCETS ONLY: Turn on the
electrical power to the electrical
outlet and pass your hand in front
of each faucet’s sensor until all
the air is purged from the lines
and water is flowing smoothly.
4. After testing is complete, reinstall
panel to frame. Fasten panel with
eight Torx-head screws provided
(see Figure 2 on page 6).
#8-32 x 3/4"
ROUND HEAD
MACHINE SCREW
BRACKET
#8 WASHER
#8 NUT
WATER
HEATER
BASE
WATER
HEATER
COVER
Figure 6a
OUTLET TO
FAUCETS
COLD WATER
SUPPLY
INLET
WATER
HEATER
CHECK/STOP
VALVE
OPTIONAL 90˚ ELBOW
PREPACKS:
EX95TMLB (S45-2186)
EX100TMLB (S45-2187)
Figure 6b