Filter
Top Products
6
Express® Deck Lavatory System EXD-Series
EXD-2N Installation Instructions
2/9/07 Bradley Corporation • 215-1542 Rev. E; EN 06-915
Installation Instructions continued . . .
Step 2: Mounting frame to wall
1. Using a T20 Torx key, remove the six #10-24 flat head Torx screws and #10 finish washers
securing the access panel to the main frame, and remove the panel (Figure 2).
2. Position the frame against the wall, ensuring that it is level.
IMPORTANT: Anchoring the frame to a wall that is not flat may cause the frame to
bend, making it difficult to reinstall the access panels.
3. Ensure that the back of the frame is flat against the wall.
4. Once you have positioned the
frame such that it is level (and
resting on the floor, standard height
frame only) and flat against the
wall, use the 3/8" bolts and 1" min.
O.D. washers to mount the frame
to the wall (Figure 3).
5. When mounting the standard
height frame, mount the scuff base
to the wall at the same time using
the two additional 3/8" bolts and
washers mentioned in Step 1,
procedure #3 on page 4 (Figure 3).
*
*
*
*
*
*
3/8" WALL ANCHORS
(4) PLACES
MAIN FRAME
SCUFF BASE FRAME
STANDARD HEIGHT
FRAME ONLY
3/8" WALL ANCHORS
(2) PLACES
STANDARD HEIGHT
FRAME ONLY
ACCESS PANEL
SCUFF PANEL
STANDARD HEIGHT
FRAME ONLY
MAIN FRAME
#10-24 PANEL FASTENERS
AND WASHERS
(6) PLACES
SCUFF PANEL FASTENERS
AND WASHERS
(4) PLACES
Figure 3
Figure 2