Filter
Top Products
B
33
B
Operating Instructions
Trouble Shooting
Minor Faults
Risk of electric shock
Repairs must only be carried out by our Customer Service
or an authorized technician.
If repairs are needed, and assuming that you cannot elim-
inate the fault youself with the aid the following table:
Turn the programme selector to Off .
Disconnect the washer-fryer from the mains.
Turn off the water tap.
Call Customer Service.
A signal emitted
in display field
E02
E01
Check whether laundry is trap-
ped in door;
Close the washer-dryer door.
Turn the tap on.
Eliminate cause.
Clean filter, see 31.
Eliminate cause.
Possible cause
Action
Door not colosed properly.
Tap not turned on.
Inlet hose kinked or pinched.
Filter blocked in water inlet
hose.
Water pressure too low.
E04
Lose debris is blocking the
pump;
Drainage pipe blocked
Clean the pump, see page 30;
Clean the drainage pipe.
Fault Possible cause Action
Detergent residue in the
detergent dispenser.
The washer-dryer door
cannot be opened.
Select Draining or Spinning .
Clean and dry the detergent
dispenser(refer to Page 30)
Use the dispensing aid for liquid
detergent.
There is water in drum.
Safety function is active.
Wait for 2 minutes.
Detergent was damp or
lumpy.
The gasket is crimped. This may appears after
installing the transport bolts.
Remove the transport bolts, operate
the machine for a period of time, the
gasket will return to the original shape.
The belt gets off the pulley. Too much laundry is in the
drum or the laundry is put in
badly, and close the window
with excessive force.
Put in the laundry well and according
to the maximum load specifiction.
,,
,,
,,
,,