Filter
Top Products
24
Operating Instructions
90 C Prewash
Detergent in chamber is
not wash away.
I
A programme without
Prewash function was
selected.
Fault Possible cause Action
Water cannot be seen in
drum.
This is not a fault.
The water lies below the visible part of the drum.
Motor noise
Pump noise
Not a malfunction! It is normal for noises to be heard while the
motor is running.
Not a malfunction! It is normal for noises to be heard from the
pump during the start or the final stage of draining the drum.
Vibrations when
washing and spinning
Transit bolts not removed. Follow the directions in the insta-
llation instructions (page 26)
The machine s feet were
not secured.
Realign the machine using a spirit
level, see the installation
instructions.
Clean the water drainage pipe
and/or drain hose.
Fluff-producing laundry was
washed at a high temperat-
ure. The water drainage
pipe or drain hose is
blocked.
Loose debris is blocking
the pump.
Washing solution is not
completely drained.
Rinse and Spin/End
indicator lights flash .
Clean the pump.
(refer to Page 20)
Leak in the drain hose.
The thread of the supply
hose is not tight.
Water is flowing out from
underneath the machine.
Tighten the thread.
Replace the drain hose.
Mix1 tablespoon of fabric softener
with 1/2 litre of water and pour
into chamber of the detergent
dispenser.
I
Foam coming out of the
detergent dispenser.
To much detergent.
Reduce the amount of detergent
next time.
Repeated spinning at short
intervals.
This is not a fault.
The imbalance compensation system is attempting to balance
the load through repeated spins.
The programme takes longer
than usual.
Wash large and small items
together to reduce imbalances.
Add a more appropriate amount
of detergent next time.
The foam detection feature
has activated an additional
rinsing cycle to reduce the
amount of foam.
This is not a fault.
The imbalance compensat-
ion system is attempting to
balance the load by distrib-
uting the laundry more
evenly.
Unsatisfactory washing
result.
Not enough detergent.
The degree of dirt was
higher than supposed.
Select a more suitable programme.
Add detergent according to the
manufacturer's specifications.
Select Cottons/coloureds
,,
,,
,