Filter
Top Products
22
Operating Instructions
Cleaning the strainer at the water tap
Disconnect the hose from the water tap.
Rinse the strainer under flowing water.
Reconnect the hose.
Cleaning the strainer on the washing machine
Disconnect the hose from the back of the washing
machine.
Pull out the stainer and rinse under running water.
Insert the strainer and reconnect the hose.
Turn on the water tap and check whether water is still
discharged. If water is still discharged, check that the
strainer is attached properly.
Turn off the water tap.
Descaling the washing machine
Descaling agents contain acids which can attack parts of the
washing machine and discolour the laundry.
Provided that you use the correct amount of detergent, it is
not necessary to descale the washing machine.
If, however, descaling the appliance becomes necessary,
please follow the instructions provided by the descaling
agent manufacturer.
Caution:
Frost protection
If the machine is located in a room which is exposed to
freezing temperatures, any residual water in both the pump
and the water inlet hose must be drained immediately every
time the machine is used.
See Cleaning the pump on page 20.
1. Turn the tap OFF.
2. Unscrew the hose from the tap and hold the end of the
hose over a container.
3. Switch ON any of the washing programmes for approxi-
mately 40 seconds. Water left inside the inlet hose will be
drained out.
4. Screw the hose back onto the tap.
Draining the pump:
Draining the water inlet hose:
,,
,,