Filter
Top Products
34
Fault Possible cause Action
Washing solution has not
drained completely.
"Drainage blocked?" indiĆ
cated in the display field.
The water drainage pipe and/or drain hose is
blocked.
Clean the water drainage pipe and/or drain hose.
Water is flowing out from The thread of the supply hose is not tight. Tighten the thread.
g
underneath the machine.
Leak in the drain hose.
Replace the drain hose.
Suds coming out of the
detergent dispenser.
Too much detergent. Mix 1 tablespoon of fabric softener with 1 pt (½ litre)
of water and pour into detergent dispenser I.
gp
Reduce the amount of detergent next time, use a low
sudsing detergent.
Repeated spinning. This is not a fault.
The imbalance compensation system is attempting to
balance the load through repeated spins.
Always load the drum with large and small items
together.
The laundry was not
spun.
Large items of clothing have become entangled and
could not be distributed evenly in the drum. For reaĆ
sons of safety the highćspeed spin cycle was autoĆ
matically suppressed.
Always load the drum with large and small items
together.
Program duration exĆ
tended.
This is not a fault.
The suds detection feature has activated an additionĆ
al rinsing cycle to reduce the amount of suds.
Add a more appropriate amount of detergent.
This is not a fault.
The imbalance compensation system is attempting to
balance the load through repeated spins.
Always load the drum with large and small items
together.
Unsatisfactory washing
result.
The degree of soiling was higher than estimated. Select suitable program
or
Power Wash as an additional option.
Not enough detergent. Add detergent according to the manufacturer's
specifications.
Detergent residue on the
laundry.
Some phosphateĆfree detergents contain waterĆinsolĆ
uble residues that may appear as light spots on the
laundry.
Brush off spots when laundry is dry.
Gray residue on the
laundry.
Dirt accumulation from ointments, fats or oils. Add the maximum amount of detergent and select
the highest permissible temperature.
Fault displays
Text in display
field
Possible cause Action
"Water tap closed?"
Water taps not turned on. Turn on water tap. Program continues.
p
Supply hose kinked or trapped. Eliminate the cause.
Strainer in supply hose clogged. Clean the water inlet strainers; see Page 30.
Water pressure too low. Eliminate the cause.
"Drainage blocked?" The water drainage pipe and/or drain hose is blocked. Clean the water drainage pipe and/or drain hose.
"Check Door!" Door not closed properly. Check whether laundry is trapped in door.
Close the door.
If the fault cannot be eliminated with the aid of the above table, switch the appliance off, wait 5 seconds, switch the
appliance on again, select and start the program.
If the fault continues, call customer service; see Page 35.