Blomberg WNF 8543 AE20 Washer User Manual


  Open as PDF
of 51
 
4 - EN
washing process and wear out.
2. Tightenallhosenutsbyhand.Neverusea
wrench when tightening the nuts.
3. Open the taps completely after making
the hose connection to check for water
leaksattheconnectionpoints.Ifanyleaks
occur, turn off the tap and remove the nut.
Retighten the nut carefully after checking
the seal. To prevent water leakages and
damagescausedbythem,keepthetaps
closed when the machine is not in use.
Connecting to the drain
• Theendofthedrainhosemustbedirectly
connected to the wastewater drain or to the
washbasin.
A
 Yourhousewillbefloodedifthehosecomes
out of its housing during water discharge.
Moreover,thereisriskofscaldingdueto
high washing temperatures! To prevent such
situations and to ensure smooth water intake
and discharge of the machine, fix the end of
the discharge hose tightly so that it cannot
come out.
• Thehoseshouldbeattachedtoaheightof
atleast40cm,and100cmatmost.
• Incasethehoseiselevatedafterlayingit
on the floor level or close to the ground
(lessthan40cmabovetheground),water
dischargebecomesmoredifficultandthe
laundry may come out excessively wet.
Therefore,followtheheightsdescribedinthe
figure.
• Topreventflowingofdirtywaterbackinto
the machine and to allow for easy discharge,
do not immerse the hose end into the dirty
waterordriveitinthedrainmorethan15
cm.Ifitistoolong,cutitshort.
• Theendofthehoseshouldnotbebent,
itshouldnotbesteppedonandthehose
mustnotbepinchedbetweenthedrainand
the machine.
• Ifthelengthofthehoseistooshort,useit
byaddinganoriginalextensionhose.Length
ofthehosemaynotbelongerthan3.2m.
To avoid water leak failures, the connection
betweentheextensionhoseandthedrain
hoseoftheproductmustbefittedwellwith
an appropriate clamp as not to come off and
leak.
Adjusting the feet
A
 Inordertoensurethattheproductoperates
moresilentandvibration-free,itmuststand
levelandbalancedonitsfeet.Balancethe
machinebyadjustingthefeet.Otherwise,
the product may move from its place and
causecrushingandvibrationproblems.
1. Loosenthelocknutsonthefeetbyhand.
2. Adjustthefeetuntiltheproductstandslevel
andbalanced.
3. Tightenalllocknutsagainbyhand.
A
 Donotuseanytoolstoloosenthelocknuts.
Otherwise, they will get damaged.
Electrical connection
Connecttheproducttoagroundedoutlet
protectedbyafusecomplyingwiththevaluesin
the"Technicalspecifications"table.Ourcompany
shallnotbeliableforanydamagesthatwillarise
when the product is used without grounding in
accordance with the local regulations.
• Connectionmustcomplywithnational
regulations.
• Powercableplugmustbewithineasyreach
after installation.
• Thevoltageandallowedfuseorbreaker
protection are specified in the “Technical
specifications”section.Ifthecurrentvalueof
 previous next