Blomberg WNF 7300 WE20 Washer User Manual


  Open as PDF
of 68
 
4
EN
• Topreventflowingofdirtywaterbackintothemachine
and to allow for easy discharge, do not immerse the
hose end into the dirty water or drive it in the drain
morethan15cm.Ifitistoolong,cutitshort.
• Theendofthehoseshouldnotbebent,itshouldnotbe
stepped on and the hose must not be pinched between
the drain and the machine.
• Ifthelengthofthehoseistooshort,useitbyadding
anoriginalextensionhose.Lengthofthehosemay
not be longer than 3.2 m. To avoid water leak failures,
the connection between the extension hose and the
drain hose of the product must be fitted well with an
appropriate clamp as not to come off and leak.
Adjusting the feet
A
Inordertoensurethattheproductoperatesmoresilent
andvibration-free,itmuststandlevelandbalancedon
its feet. Balance the machine by adjusting the feet.
Otherwise, the product may move from its place and
cause crushing and vibration problems.
1. Loosenthelocknutsonthefeetbyhand.
2. Adjust the feet until the product stands level and
balanced.
3. Tighten all lock nuts again by hand.
A
Donotuseanytoolstoloosenthelocknuts.Otherwise,
they will get damaged.
Electrical connection
Connect the product to a grounded outlet protected by a fuse
complying with the values in the "Technical specifications"
table. Our company shall not be liable for any damages that
will arise when the product is used without grounding in
accordance with the local regulations.
• Connectionmustcomplywithnationalregulations.
• Powercableplugmustbewithineasyreachafter
installation.
• Thevoltageandallowedfuseorbreakerprotectionare
specifiedinthe“Technicalspecifications”section.Ifthe
current value of the fuse or breaker in the house is less
than16Amps,haveaqualifiedelectricianinstalla16
Amp fuse.
• Thespecifiedvoltagemustbeequaltoyourmains
voltage.
• Donotmakeconnectionsviaextensioncablesormulti-
plugs.
B
Damagedpowercablesmustbereplacedbythe
Authorized Service Agents.
First use
Before starting to use the product, make sure that all
preparations are made in accordance with the instructions in
sections"Importantsafetyinstructions"and"Installation".
To prepare the product for washing laundry, perform first
operationinDrumCleaningprogramme.Ifyourmachineis
notfeaturedwithDrumCleaningprogramme,useCottons-90
programme and select Additional Water or Extra Rinse
auxiliary functions as well. Before starting the programme,
putmax.100gofpowderanti-limescaleintothemain
washdetergentcompartment(compartmentnr.II).Ifthe
anti-limescaleisintabletform,putonlyonetabletinto
compartmentnr.II.Drytheinsideofthebellowwithaclean
piece of cloth after the programme has come to an end.
C
Useananti-limescalesuitableforthewashing
machines.
C
Some water might have remained in the product due to
thequalitycontrolprocessesintheproduction.Itisnot
harmful for the product.
Disposing of packaging material
Packagingmaterialsaredangeroustochildren.Keep
packaging materials in a safe place away from reach of the
children.
Packaging materials of the product are manufactured from
recyclablematerials.Disposeofthemproperlyandsortin
accordancewithrecycledwasteinstructions.Donotdispose
of them with normal domestic waste.
Transportation of the product
Unplugtheproductbeforetransportingit.Removewaterdrain
andwatersupplyconnections.Draintheremainingwaterin
theproductcompletely;see,"Drainingremainingwaterand
cleaningthepumpfilter".Installtransportationsafetyboltsin
thereverseorderofremovalprocedure;see,"Removingthe
transportation locks".
 previous next