Blomberg WMT 8320 S Washer User Manual


 
EN
56
If the filter cap is one piece, pull the cap
from both sides at the top to open.
C
You can remove the filter cover by
slightly pushing downwards with a
thin plastic tipped tool, through the
gap above the filter cover. Do not
use metal tipped tools to remove the
cover.
3. Some of our products have
emergency draining hose and some
does not have. Follow the steps
below to discharge the water.
Discharging the water when the product
has an emergency draining hose:
a. Pull the emergency draining hose
out from its seat
b. Place a large container at the end
of the hose. Drain the water into
the container by pulling out the plug
at the end of the hose. When the
container is full, block the inlet of
the hose by replacing the plug. After
the container is emptied, repeat the
above procedure to drain the water
in the machine completely.
c. When draining of water is finished,
close the end by the plug again and
fix the hose in its place.
d. Turn the pump filter to take it out.
Discharging the water when the product
does not have an emergency draining
hose:
a. Place a large container in front of the
filter to catch water from the filter.
b. Loosen pump filter (anticlockwise)
until water starts to flow. Fill the
flowing water into the container
you have placed in front of the filter.
Always keep a piece of cloth handy
to absorb any spilled water.
c. When the water inside the machine
is finished, take out the filter
completely by turning it.
4. Clean any residues inside the filter
as well as fibers, if any, around the
pump impeller region.
5. Install the filter.
A
If your product has a water jet
feature, be sure to fit the filter into
its housing in the pump. Never force
the filter while installing it into its
housing. Seat the filter into its place
completely. Otherwise, water may
leak from the filter cap.
6. If the filter cap is composed of
two pieces, close the filter cap by
pressing on the tab. If it is one piece,
seat the tabs in the lower part into