Filter
Top Products
6
EN
water drain hose supplied with the product instead of
periodically draining the water collected in the water
tank.
Connecting the water drain hose
1. Pull hose in the product by hand in order to
disconnect it from where it is connected. Do not
use any tools to remove the hose.
2. Connect one end of the drain hose supplied
separately with the product to the connection point
from where you removed the hose of the product
in previous step.
3. Connect the other end of the drain hose directly to
the wastewater drain or to the washbasin.
A
Hose must be fixed in every type of connection.
Your house will be flooded if the hose comes loose
during water discharge.
C
Water drain hose should be attached to a height of
maximum 80 cm.
C
Make sure that the water drain hose is not stepped
on and it is not folded between the drain and the
machine.
Adjusting the feet
In order to ensure that the product operates more
silently and vibration-free, it must stand level and
balanced on its feet. Balance the machine by adjusting
the feet.
Turn the feet to left or right until the machine stands
level and firmly.
C
Never remove the adjustable feet from their
housings.
Electrical connection
Connect the product to a grounded outlet protected
by a fuse complying with the values in the "Technical
specifications" table. Our company shall not be liable
for any damages that will arise when the product is
used without grounding in accordance with the local
regulations.
• Connection must comply with national regulations.
• Power cable plug must be within easy reach after
installation.
• The voltage and allowed fuse or breaker protection
are specified in the “Technical specifications”
section. If the current value of the fuse or breaker
in the house is less than 10 Amps, have a qualified
electrician install a 10 Amp fuse.
• The specified voltage must be equal to your mains
voltage.
• Do not make connections via extension cables or
multi-plugs.
• The main fuse and switches must have a contact
distance of minimum 3 mm.
B
Damaged power cable must be replaced by the
Authorized Service Agent.
B
If the product is faulty, it must not be operated
unless it is repaired! There is the risk of electric
shock!