Blomberg TKF 7330 A Clothes Dryer User Manual


  Open as PDF
of 44
 
15 - EN
detected by sensors during a drying
cycle and the remaining time is
updated automatically.
Canceling the time delay
If you want to cancel the time delay
countdownandstarttheprogram:
1. Pressthe“Start/Pause/Cancel”
buttonforabout4seconds.The“:”
in the middle of the screen will stop
flashing.The“Start/Pause/Cancel”
light will go off and the remaining time
on the screen disappears.
2. Pressthe"Start/Pause/Cancel"
button to start the program right
away.
Starting the Program
1. Pressthe"Start/Pause/Cancel"
button to start the program.
2. The“Start/Pause/Cancel”buttonwill
light up to indicate that the program
has started.
Progress of program
Progressofarunningprogramisshown
through the program follow-up indicator.
At the beginning of every program step,
the relevant indicator lamp will light up
and light of the completed step will turn
off.
"Drying":
- Drying level will be illuminated during
the whole drying process until the drying
degree reaches "iron dry".
"Iron Dry":
- Starts to illuminate when the drying
degree reaches "iron dry" step and
remains illuminated until the next step.
"Cupboard Dry":
- Starts to illuminate when the drying degree
reaches "Cupboard dry" step and remains
illuminated until the next step.
“Cooling”:
- It lights up during the 4-minute cooling
phase at the end of drying.
“Final / Anti-creasing”:
- Illuminates when the program comes
to an end and anti-creasing function is
activated.
Important:
If more than one LED light up or
flash concurrently, it means there is
malfunctioning or a failure (please see,
Solution suggestions for problems).
Changing the program after the
program has started
Youcanusethisfeatureafteryourmachine
has started to dry your clothes under higher
or lower temperatures.
For example;
Pressandholdthe“Start/Pause/Cancel”
buttonforabout4secondsto“Cancel”
theprograminordertoselect“ExtraDry”
programinsteadof“IronReady”program.
Selectthe“ExtraDry”programbyrotating
the program knob.
Pressthe"Start/Pause/Cancel"buttonto
start the program.
C The program which is selected first will
go on even if the program selection
button is moved and another program
mode is selected while the machine is
operating.Youmustcanceltheongoing
program in order to change the drying
program. (See, Ending the program
through canceling)
Adding/removing laundry in standby
mode
In order to add or take out laundry after the
start-up of the program;
1. Pressthe“Start/Pause/Cancel”button
toswitchthemachineto“Pause”mode.
Drying process will stop.
2. OpenthedooratStoppositionand
close it again after adding or taking out
laundry.
3. Press"Start/Pause/Cancel"buttonto
start the program.
C Any laundry added after the drying
process was started may cause the
already dried clothes in the machine
intermingle with wet clothes and the
 previous next