Beko WMY 712832 Washer User Manual


 
20 / EN
Washng Machne / User’s Manual
4.3.11.3 Addng or takng out laundry
1. Press the Start / Pause button to switch the machine to pause mode. The programme follow-up
light of the relevant step during which the machine was switched into the pause mode will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out the laundry.
5. Close the Loading Door.
6. Make changes in auxiliary functions, temperature and speed settings if necessary.
7. Press Start/Pause button to start the machine.
4.3.12 Chld Lock
Use Child Lock function to prevent children from tampering with the machine. Thus you can avoid
any changes in a running programme.
C
You can switch on and off the machine with On / Off button when the Child Lock is active. When you switch on
the machine again, programme will resume from where it has stopped.
4.3.12.1 To actvate the chld lock:
Press and hold Auxiliary Function button 2 for 3 seconds. In the programme selection display on
the panel, "Child lock enabled" light will turn on. You can release Auxiliary Function button 2 when
this warning is displayed.
4.3.12.2 To deactvate the chld lock:
Press and hold Auxiliary Function button 2 for 3 seconds. In the programme selection display on
the panel, "Child lock enabled" light will turn off.
4.3.13 Cancelng the programme
The programme is cancelled when the machine is turned off and on again. Press and hold On / Off
button for 3 seconds.
C
If you press On / Off button when the Child Lock is enabled, the programme will not be cancelled. You should
cancel the Child Lock first.
If you want to open the loading door after you have cancelled the programme but it is not possible to open
the loading door since the water level in the machine is above the loading door opening, then turn the
Programme Selection knob to Pump+Spin programme and discharge the water in the machine.
4.3.14 End of programme
End LED appears on the display when the programme is completed.
If you do not press any button for 10 minutes, the machine will switch to OFF mode. Display and all
indicators are turned off.
Completed programme steps will be displayed if you press On / Off button.
4.3.15 Your machne features "Standby Mode".
After you switch on your machine with On-Off button, if no program is started or no other procedure
is performed at the selection step or no action is taken within approx. 10 minutes after the selected
program ends, your machine will switch to OFF mode automatically. Display and all indicators are
turned off. Selected programme data will be displayed if you press On / Off button. Before you start
the program, check the accuracy of your selections. If necessary, repeat them. This is not an error.