Filter
Top Products
EN
31
Detergent
residue in the
dispensing
drawer.
Detergent may have been
put in wet dispenser
drawer.
Dry the detergent drawer before putting in
detergent.
Detergent may have
gotten damp.
Store detergent in a closed and dry place. Do
not keep them under high temperatures.
Water pressure might be
low
The detergent in the main
wash compartment might
have gotten wet while
taking in the prewash
water..
The detergent dispenser outlet (holes) may
have a problem.
There might be problems with the detergent
dispenser valves.
Detergent might be mixed
with the bleaching agent.
Softener should not come into contact with
detergent when being added.
There is
detergent left
on the laundry.
Excessive laundry might
have been loaded in.
Do not load the machine in excess.
Wrong program and
temperature might have
been selected.
Select the proper program and temperature
for the laundry to be washed.
Wrong detergent may
have been used.
Use wool detergents for woolens.
There is too
much foam.
You may not be using
proper detergent for
automatic washing
machines.
Use only automatic washing machine
detergents in your washing machine.
Excessive amount of
detergent may have been
used.
Use only sufficient amount of detergent.
Too much detergent may
have been used for a
small amount of lightly
soiled laundry.
Use only sufficient amount of detergent.
Detergent may have been
stored improperly.
Store detergent in a closed and dry location.
Do not store in excessively hot places.
Type of material being
washed (lace items will
cause excessive foam due
to their meshed structure).
Use smaller amounts of detergent for lace
items.
Detergent might have
been put in the wrong
compartment.
If you put detergent in the prewash
compartment although you have not selected
a prewash cycle, the machine can take this
detergent during rinsing or softener step.
Softener being released
early.
You may have added too much softener.
The detergent dispenser might be
problematic. Water may be siphoned (pulling
the softener into the washer early) during the
fill or rinse cycles.
There might be problems with the valves.