Beko WMP 511S Washer User Manual


  Open as PDF
of 20
 
3/EN
Washing Machine / User’s Manual
2 Installation
RefertothenearestAuthorisedServiceAgentforinstallation
oftheproduct.Tomaketheproductreadyforuse,review
the information in the user manual and make sure that the
electricity,tapwatersupplyandwaterdrainagesystemsare
appropriatebeforecallingtheAuthorizedServiceAgent.Ifthey
arenot,callaqualifiedtechnicianandplumbertohaveany
necessary arrangements carried out.
C
INFORMATIONS
Preparationofthelocationandelectrical,tapwaterandwaste
water installations at the place of installation is under customer’s
responsibility.
Make sure that the water inlet and discharge hoses as well as the
powercablearenotfolded,pinchedorcrushedwhilepushingthe
product into its place after installation or cleaning procedures.
B WARNING
Installationandelectricalconnectionsoftheproductmustbe
carriedoutbytheAuthorizedServiceAgent.Manufacturershallnot
beheldliablefordamagesthatmayarisefromprocedurescarried
outbyunauthorizedpersons.
A WARNING
Priortoinstallation,visuallycheckiftheproducthasanydefectson
it.Ifso,donothaveitinstalled.Damagedproductscauserisksfor
your safety.
2.1 Appropriate installation location
• Placethemachineonarigidfloor.Donotplaceitonalong
pile rug or similar surfaces.
• Totalweightofthewashingmachineandthedryer-with
full load- when they are placed on top of each other
reachestoapprox.180kilograms.Placetheproductona
solid and flat floor that has sufficient load carrying capacity!
• Donotplacetheproductonthepowercable.
• Donotinstalltheproductatplaceswheretemperaturemay
fallbelow0ºC.
• Placetheproductatleast1cmawayfromtheedgesof
other furniture.
2.2 Removing packaging reinforcement
Tiltthemachinebackwardstoremovethepackaging
reinforcement.Removethepackagingreinforcementby
pullingtheribbon.
2.3 Removing the transportation locks
A WARNING
Donotremovethetransportationlocksbeforetakingoutthe
packaging reinforcement.
Removethetransportationsafetyboltsbeforeoperatingthe
washingmachine!Otherwise,theproductwillbedamaged.
Loosenalltheboltswithasuitablespanneruntiltheyrotate
freely(C).Removetransportationsafetyboltsbyturningthem
gently.AttachtheplasticcoverssuppliedintheUserManual
bagintotheholesontherearpanel.(P)
C
INFORMATIONS
Keepthetransportationsafetyboltsinasafeplacetoreusewhen
thewashingmachineneedstobemovedagaininthefuture.
Nevermovetheproductwithoutthetransportationsafetybolts
properly fixed in place!
2.4 Connecting water supply
C
INFORMATIONS
Thewatersupplypressurerequiredtoruntheproductisbetween
1to10bars(0.1–1MPa).Itisnecessarytohave10–80liters
of water flowing from the fully open tap in one minute to have your
machinerunsmoothly.Attachapressurereducingvalveifwater
pressure is higher.
Ifyouaregoingtousethedoublewater-inletproductasasingle
(cold)water-inletunit,youmustinstallthesuppliedstopperto
thehotwatervalvebeforeoperatingtheproduct.(Appliesforthe
productssuppliedwithablindstoppergroup.)
Ifyouwanttousebothwaterinletsoftheproduct,connectthe
hot water hose after removing the stopper and gasket group from
thehotwatervalve.(Appliesfortheproductssuppliedwithablind
stopper group.)
A WARNING
Modelswithasinglewaterinletshouldnotbeconnectedtothe
hotwatertap.Insuchacasethelaundrywillgetdamagedorthe
product will switch to protection mode and will not operate.
Donotuseoldorusedwaterinlethosesonthenewproduct.Itmay
cause stains on your laundry.
Connectthespecialhosessuppliedwiththeproducttothe
waterinletsontheproduct.Redhose(left)(max.90ºC)isfor
hotwaterinlet,bluehose(right)(max.25ºC)isforcoldwater
inlet.
1.6 Compliance with the WEEE Directive
and Disposing of the Waste Product:
ThisproductcomplieswithEUWEEEDirective
(2012/19/EU).Thisproductbearsaclassification
symbolforwasteelectricalandelectronic
equipment(WEEE).
Thisproducthasbeenmanufacturedwithhigh
qualitypartsandmaterialswhichcanbereused
andaresuitableforrecycling.Donotdisposeof
the waste product with normal domestic and other wastes at
the end of its service life. Take it to the collection center for
therecyclingofelectricalandelectronicequipment.Please
consultyourlocalauthoritiestolearnaboutthesecollection
centers.
 previous next