Beko WME 8227 W Washer User Manual


  Open as PDF
of 40
 
EN
20
Auxiliary functions
Auxiliary function selection keys
• Dependingontheprogramme,
you can select the desired auxiliary
function by pressing the buttons.
• Selecttherequiredauxiliary
functions before starting the
programme.
• Somecombinationscannotbe
selectedtogether.(Ex.:Prewash
and Quick Wash.
• Symboloftheselectedauxiliary
function(Figure2-2l)willlightup.
Auxiliary function selection
If an auxiliary function that should not
be selected together with a previously
selected function is chosen, the first
selected function will be cancelled and
the last auxiliary function selection will
remain active.
(Ex.:Ifyouwanttoselectprewashfirst
and then quick wash, prewash will be
cancelled and quick wash will remain
active.
Auxiliary function that is not compatible
with the programme cannot be selected.
(see,“ProgrammeSelectionTable”)
• Prewash
When you select this function, the
display will indicate “F1” symbol.
• Aprewashisonlyrequiredwith
heavily soiled laundry. Without
prewash you save energy, water,
detergent and time.
• Prewashwithoutdetergentis
recommended for veils and curtains.
• Quick Wash
With this programme, the wash time is
shortened. “F2” symbol will light up on
the display.
• Usethisfunctionforsmaller
amounts or slightly soiled laundries.
• Extra Rinse
This function allows your machine to
perform an extra rinsing in addition to
the rinsing cycles performed by your
machine after main washing cycle.
Thus,theriskforsensitiveskins(babies,
allergicskinsandetc.)tobeeffectedby
the minimal detergent remnants on the
laundry is reduced. “F3” symbol will light
up on the display.
• Anti- Crease
With this function, boiler movement will
be lessened to prevent creasing and
spinning speed is limited. In addition,
washing is carried out at a higher water
level. “F4” symbol will light up on the
display.
• Usethisfunctionfordelicate
laundries that crease easily.
C Whenever you select this auxiliary
function, load your machine with
half of the maximum laundry amount
specified in the programme table.
Time screen
The display shows the time remaining
for the programme to complete while a
programme is running. Time is displayed
inhoursandminutesas“01:30”.
Time delay
With the “Time delay” function you can
delay the programme start up to 24
hours. Setting can be made in intervals
of 30 minutes.
1. Opentheloadingdoor,placethe
laundry inside and fill with detergent.
2. Set the washing programme,
temperature, spin speed and,
7a 7b 7c 7d
 previous next