Beko WME 7227 W Washer User Manual


 
EN
30
The door is jammed.
- Water level might be above the lower
level of the door.
-Machinemightbeheatingupthewa-
ter or it may be at the spinning cycle.
- Due to an electrical mechanism, the
door can only be opened a few min-
utes after the programme has stopped.
-Runeitherthe“Pump”or“Spin”programme.
- Wait until the process is over.
- Wait until the process is over.
Machinefillswithwaterwhenaprocessiscancelled.
Inside of machine may be hot.
For safety reasons, water should be cycled in and
out a couple times.
Itcontinuouslyspins.Remainingtimedoesnotcountdown.(Onmodelswithdisplay)
There may be an imbalance of laundry
in the machine.
- The automatic spin correction system might have
been activated due to the unbalanced distribution
of the laundry in the drum.
-Thelaundryinthedrummaybeclustered(bun-
dledlaundryinabag).Laundryshouldberear-
ranged and re-spun.
- No spinning is performed when the laundry is not
evenly distributed in the drum to prevent any dam-
age to the machine and to its environment.
Washing time takes longer than the time specified in the manual
- Water pressure may be low.
- Supply voltage may be low.
- Input temperature of water may be
low.
- There may be an imbalance of laun-
dry in the machine.
- Number of rinses and/or amount of
rinse water might have increased.
- The machine will wait until there is sufficient
amount of water, which will lengthen the washing
time to avoid poor washing results due to insuf-
ficient water.
- Washing time is extended to avoid poor washing
results when the supply voltage is low.
- Cycle time is extended to heat up the water when
the input water is cold. Also, washing time can be
lengthened to avoid poor washing results.
- The automatic spin correction system might have
been activated due to the unbalanced distribution
of the laundry in the drum.
-Thelaundryinthedrummaybeclustered(bun-
dledlaundryinabag).
- Laundry should be rearranged and re-spun.
- No spinning is performed when the laundry is not
evenly distributed in the drum to prevent any dam-
age to the machine and to its environment.
- Water amount is increased to obtain a better
rinse and a rinse cycle is added when necessary.