Beko WMB 61032 M Washer/Dryer User Manual


 
15 / 76 EN
Washing Machine / User’s Manual
1.Closethetaps.
2. Remove the nuts of the water intake hoses to access
thefiltersonthewaterintakevalves.Cleanthemwithan
appropriatebrush.Ifthefiltersaretoodirty,takethemout
bymeansofpliersandcleanthem.
3. Take out the filters on the flat ends of the water intake
hoses together with the gaskets and clean thoroughly
under running water.
4. Replace the gaskets and filters carefully in their places
andtightenthehosenutsbyhand.
5.5 Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid items
suchasbuttons,coinsandfabricfiberscloggingthepump
impellerduringdischargeofwashingwater.Thus,thewater
willbedischargedwithoutanyproblemandtheservicelife
of the pump will extend.
Ifthemachinefailstodrainwater,thepumpfilterisclogged.
Filtermustbecleanedwheneveritiscloggedorinevery3
months.Watermustbedrainedofffirsttocleanthepump
filter.
Inaddition,priortotransportingthemachine(e.g.,when
movingtoanotherhouse)andincaseoffreezingofthe
water,watermayhavetobedrainedcompletely.
A
warning: Foreignsubstancesleftinthepumpfiltermay
damageyourmachineormaycausenoiseproblem.
Inordertocleanthedirtyfilteranddischargethewater:
1.Unplugthemachinetocutoffthesupplypower.
A
warning: Temperature of the water inside the machine
mayriseupto90ºC.Toavoidburningrisk,filtermustbe
cleaned after the water in the machine cools down.
2. Open the filter cap.
Ifthefiltercapiscomposedoftwopieces,pressthe
tabonthefiltercapdownwardsandpullthepieceout
towards yourself.
Ifthefiltercapisonepiece,pullthecapfrombothsidesat
the top to open.
C
Youcanremovethefiltercoverbyslightlypushing
downwardswithathinplastictippedtool,throughthe
gapabovethefiltercover.Donotusemetaltippedtools
to remove the cover.
5.2 Cleaning the loading door and the drum
Residuesofsoftener,detergentanddirtmayaccumulate
in your machine in time and may cause unpleasant odours
andwashingcomplaints.Toavoidthis,usetheDrum
Cleaningprogramme.Ifyourmachineisnotfeaturedwith
Drum Cleaningprogramme,useCottons-90programme
and select Additional Water or Extra Rinse auxiliary
functionsaswell.RuntheBeforestartingtheprogramme,
put max. 100 g of powder anti-limescale into the main
washdetergentcompartment(compartmentnr.2).Ifthe
anti-limescaleisintabletform,putonlyonetabletinto
compartmentnr.2.Drytheinsideofthebellowwithaclean
piece of cloth after the programme has come to an end.
C
RepeatDrumCleaningprocessinevery2months.
C
Useananti-limescalesuitableforthewashingmachines.
Aftereverywashingmakesurethatnoforeignsubstanceis
left in the drum.
Iftheholesonthebellowshowninthefigureisblocked,
open the holes using a toothpick.
C
Foreignmetalsubstanceswillcauseruststainsinthe
drum.Cleanthestainsonthedrumsurfacebyusing
cleaning agents for stainless steel. Never use steel wool
or wire wool.
A
warning: Neverusespongeorscrubmaterials.These
will damage the painted and plastic surfaces.
5.3 Cleaning the body and control panel
Wipethebodyofthemachinewithsoapywaterornon-
corrosivemildgeldetergentsasnecessary,anddrywitha
soft cloth.
Useonlyasoftanddampclothtocleanthecontrolpanel.
5.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the
rear of the machine and also at the end of each water intake
hose where they are connected to the tap. These filters
preventforeignsubstancesanddirtinthewatertoenterthe
washingmachine.Filtersshouldbecleanedastheydoget
dirty.