Beko WMB91242LB Washer User Manual


  Open as PDF
of 40
 
7 - EN
always be securely fastened and remain
in an undamaged state.
• Fitthedraininghosetoawashbasinor
waste system securely before starting
up your machine. There may be a risk
of being scalded due to high washing
temperatures!
• Neveropenthedoororremovethefilter
while there is still water in the drum.
Otherwise,theremaybetheriskof
flooding and possible injury due to the
hot water.
• Neverforceopenthelockeddoor!The
door will be ready to open just a few
minutes after the washing cycle comes
to an end.
• Unplugthemachinewhenitisnotin
use.
• Neverwashdowntheappliancewitha
water hose! There is the risk of electric
shock! Always disconnect from the
mains by unplugging before cleaning.
• Nevertouchtheplugwithwethands.
Never unplug by pulling on the cable,
always pull out from the plug only. Do
not operate the machine if the power
cord or plug is damaged.
• Neverattempttorepairthemachine
yourself.Otherwise,youmaybeputting
yours and other’s lives in danger.
• Formalfunctionsthatcannotbesolved
byinformationintheoperatingmanual:
Turn off the machine, unplug it, turn
off the water tap and contact an
Authorised service agent.
If there are children in your
house...
• Electricalappliancesmaybedangerous
forthechildren.Keepchildrenaway
from the machine when it is operating.
Do not let them tamper with the
machine.
• Closethedoorwhenyouleavethearea
where the machine is located.
• Storealldetergentsinasafeplaceout
of reach of the children.
• UseChild/Keylocktopreventchildren
altering the settings
Electrical connection
Makesurethatyouhaveanearthedpower
outletsocketratedat13amps(minimum).
Attention!
If you place your machine under a worktop,
the socket must be reachable after
installation,oraseparateswitch(whichcan
disconnectthetwopoles)mustbeusedin
the installation.
Connect the power cord to the appropriate
electrical socket with an equivalent current
rating indicated on the rating plate at the
front of the machine behind the kick plate.
After removing the plug from its transit
position, please insert the plug seal to
prevent water spillage entering the machine.
Electrical requirements
Beforeyouinserttheplugintothewall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitable
switched and fused socket in a readily
accessible position.
Should the mains lead of the appliance
become damaged or need replacing at
any time, it must be replaced by a special
purpose made mains lead which can only
be obtained from a Authorised Service
Agent.
B
This appliance must be earthed
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut off
and an appropriate plug fitted.
Destroy the old plug, which is cut off as a
plug with a bare cord could cause a shock
hazard if inserted into a socket elsewhere in
the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the fuse
need to be replaced an ASTA approved
BS1362fuseofthesameratingmustbe
used. Do not forget to refit the fuse cover.
In the event of losing the fuse cover, the
plug must not be used until a replacement
fuse cover has been fitted. Colour of the
replacement fuse cover must be the same
colour as that visible on the pin face of the
 previous next